Configuring the CIP Card and the Virtual Interfaces

CIP cards appear on the router as a controller rather than a standard interface. T1 duct may define, modify, or delete without any external configuration card. CSU cycle may boot and run from the software release and test patterns in these loops from the router. Full management advantages are well known to anyone who has any time at all to perform network operations technician jobs. Reported power outages to the carrier's ability to quickly determine when CSU State, trying to quickly fix and get a complete diagnosis issues and valuable. During the initial report can provide them with more information that often can greatly speed up, diagnose and repair process.

T3 controller, because it is built on a VIP2 technologies introduced into the third level is specified. Rather than simply slot/Port, it does not introduce an adapter port number. Because only one CT3IP per card, ports and port adapter number is always zero. In slot 2 of the interface will be identified as 2/0/0. T1 duct after (number by 28 to tie belcore specify 1) interface identifier is designated by a colon and a channel number. In the preceding example, the 17th T1 channel.

 

The interface configuration of the T3 is the first step. T3 framework, clock source and cable distances (this is used to determine) the settings that you want. Default is 224 feet cable length. This should be acceptable for most applications. Our website supports frame type cbit and the m23. It is possible to configure the router automatically detects frame but in many cases, automatic may cause problems in the future so it is best to use this only if you're not sure is using frames. Once you have determined the framework, it can then set up a static router configuration.

For most of the muxed T3s, frame type the m23. For example, used in clear channel T3 ATM networks, cbit.

 

  controller t3 0/0/0
  framing m23
  clock source line
  cablelength 224

 

Once you have configured T3,T1 pipes may be assigned. T1 duct needs to be configured to use Foundation, framing and coding is in use, speed of DS0s on the T1 slot number (56 k or 64 k), and T1 clock source.

 

controller t3 0/0/0
  t1 1 timeslots 1-24 speed 64
  t1 1 clock source line
  t1 1 framing esf
  t1 1 linecone b8zs

 

Once you have configured the T3,T1 tube may be assigned. T1 tube needs to be configured to use Foundation, framing and coding is in use, the T1 slot number of DS0s (56 k or 64 k) and T1 speed of the clock source.

 

After the T1 configuration, the router will create a virtual serial interface. Until the T1 has been created and determined in the same manner as described above, this interface does not appear. For example, for refference first T1 serial interface, it will be identified as serial 0/0/0:1. This interface can be used as any other serial interface beconfigured.

Levels starting from the interface loopback test. T3 also may be back from the controller configuration cycles. It is important to note the configuration from the controller could not possibly ring T1.

 

 interface Serial0/0/0:1
  loopback network
The loop is removed by specifying "no loopback network" in the interface configuration.